Enter the callsign of  
  the station contacted. 
  Enter the date of the 
  contact in MM/DD/YY
  format.
  Enter the continent
  (i.e. OCEANIA or EUROPE) 
  for the desired country. 
  Enter the latitude of the 
  desired country using the 
  following format:  dd.mm  
a	 	%N
  Enter the longitude of the 
  desired country using the  
  following format:
	!	'N
  Enter the name of the
  country associated with 
  the callsign prefix
  previously entered.
  Enter the callsign prefix 
  of the desired country.
Ex: EA for Spain.
  Enter the two digit ITU
  zone for desired prefix.  
  Enter the frequency (in Khz) 
  of the contact.
!``  
  Enter N for north latitudes, 
  enter S for south latitudes. 
!``  
  Enter E for east longitudes, 
  enter W for west longitudes. 
!``  
  Valid Values:  
  Enter the name of the 
  operator contacted.
  Enter the power (in watts) 
  used during the contact.
  Enter information (such as  
  address, QSL manager, QSL
  via bureau or callbook) to  
  receive QSL from contact.
 ``  
  Enter the location of  
  the station contacted. 
RST Codes
For CW:
For SSB:
  Readability  1 - 5
Readability
1 - 5
  Strength
1 - 9
Strength
1 - 9
  Tone
 	1 - 9
5``  
  Enter the start/end time of the  
  QSO using a 24 hour clock.  Use  
  of UTC time is recommended.
%``  
!CALL    
DATE    
DX_CONT j
DX_LAT  :
DX_LONG 
DX_NAME 
DX_PREFI
DX_ZONE 
FREQ    {
LAT_SPEC"
LONG_SPE
MODE    
NAME    
POWER   g
QSL     
QTH     
RST     
TIME    k